If you are considering installing a set of LED light bars on your motorcycle, there are several things that you need to consider before you start wiring them up. One of the most important is to ensure that your wires are not touching any hot parts of your bike such as the muffler, exhaust or a chain or sprocket. This will ensure that your new lights will not get damaged from the heat that these areas produce.

First, you will need to find a good mounting location for your LED light bar. This will ensure that your new lights are in the best possible position to be used while you are riding your motorcycle. Once you have found a suitable mounting location, mark the location of the holes that you will need to drill. You may need to adjust these holes in the future, so be sure not to overtighten them as this could cause them to fall off.

Next, you will need to connect the power wires of your LED light bar to the positive and negative leads on your bike’s battery. This is an essential step since it will help your LEDs to run at full brightness without overheating the wires.

Now, you will need to connect the wires from the LED light bar to your switch as well as the other terminals on the light bar’s relay. This is a critical step as it will prevent you from having any electrical problems down the road due to a broken connection or a short circuit in your system.

You can either solder your connections or use butt connectors. Either method will make sure that your connections will last a long time and be extremely secure.

Alternatively, you can simply plug the positive and negative wires from your new light bar directly into the positive and negative leads on your bike’s switch. This will make your new LED lights work right away.

This will ensure that your LED light bar will have no issues working with the switch that you have installed on your motorcycle. Once your new LED light bar is in place and all of the connections are correctly made, you will need to turn on your bike’s high beams and test that the lights are working properly. If they do not, then you have a problem with the lighting and need to go back and fix it.

Finally, you will need to connect the wiring from your new LED light bar to your switch as well as to the other terminals on the light bar’s relay. This is an essential step since it will prevent you from having any electrical problems Down The Road as it will help your LEDs to run at top brightness without overheating the wires.

Once you have connected the wiring from your new LED light bar to the switch as well as to the other terminals of the light bar’s relay, you will need to turn on your bike’s High Beams and test that the lights are working properly. This will ensure that they do not break your law and you can drive your bike safely with the new lights.